Igmp Snooping Commands - D-Link DES-3010F Command Line Interface Manual

The IGMP Snooping commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config igmp_snooping
config igmp_snooping querier
config router_ports
enable igmp snooping
disable igmp snooping
show igmp snooping
show igmp snooping group
show router_ports
Each command is listed, in detail, in the following sections.
config igmp_snooping
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DES-3000 Series Layer 2 Switch CLI Reference Manual
Parameters
[vlan_name <vlan_name 32> | all] {host_timeout <sec 1-16711450>
| router_timeout <sec 1-16711450> | leave_timer <sec 1-
16711450> | state [enable | disable] | fast_leave [enable | disable]}
[vlan_name <vlan_name 32> | all] {query_interval <sec 1-65535>|
max_response_time <sec 1-25> robustness_variable <value 1-
255> | last_member_query_interval <sec 1-25> | state [enable |
disable]
<vlan_name 32> [add | delete] <portlist>
{forward_mcrouter_only}
{vlan <vlan_name 32>}
{vlan <vlan_name 32>}
{vlan <vlan_name 32>} {[static | dynamic]}
Used to configure IGMP snooping on the Switch.
config igmp_snooping [vlan_name <vlan_name 32> | all] {host_timeout
<sec 1-16711450> | router_timeout <sec 1-16711450> | leave_timer <sec 1-
16711450> | state [enable | disable] | fast_leave [enable | disable]}
This command allows the user to configure IGMP snooping on the Switch.
vlan_name <vlan_name 32> − The name of the VLAN for which IGMP
snooping is to be configured.
all – Selecting this parameter will configure IGMP for all VLANs on the Switch.
host_timeout <sec 1-16711450> − Specifies the maximum amount of time a
host can be a member of a multicast group without the Switch receiving a host
membership report. The default is 260 seconds.
router_timeout <sec 1-16711450> − Specifies the maximum amount of time a
route can be a member of a multicast group without the Switch receiving a host
membership report. The default is 260 seconds.
leave_timer <sec 1-16711450> − Leave timer. The default is 2 seconds.
state [enable | disable] − Allows the user to enable or disable IGMP snooping
for the specified VLAN.
fast_leave [enable | disable] – This parameter allows the user to enable the fast
leave function. Enabled, this function will allow members of a multicast group to
leave the group immediately (without the implementation of the Last Member
Query Timer) when an IGMP Leave Report Packet is received by the Switch.
Only administrator-level users can issue this command.
IGMP S
NOOPING
124
22
C
OMMANDS