Indicate Transmission Failure; Disable Character - Datalogic QuickScan I QM21X1 Product Reference Manual

RS-232/USB-COM Interfaces

Indicate Transmission Failure

This option enables/disables the reader's ability to sound an error beep to indi-
cate a transmission failure while in ACK/NAK mode.
$CR2TF01
Indicate Transmission Failure = Enable Indication

Disable Character

Specifies the value of the RS-232 host command used to disable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected. See
Character"
NOTE
$CR2DC
Select Disable Character Setting
Product Reference Guide

on page 283 for more detailed programming instructions.
Setting to previously defined characters such as XON, XOFF, or
host commands conflicts with normal operation of these char-
acters. 8-bit data is not recognized when the option Data Bits
on page 27 has been set as 7 Data Bits.
0x44 = Disable Character is 'D'
DEFAULT
Enter/Exit Programming Mode
$CR2TF00
Indicate Transmission Failure = Disable Indication
DEFAULT

"Disable
39