Bt Security Features; Bt Security Mode - Datalogic QuickScan I QM21X1 Product Reference Manual

On the BT system, it is possible to set a (configurable) PIN code to authenticate/
connect BT devices, and encrypt the data.
The BT PIN code can be enabled and configured by reading the bar codes in the
following sections.
If you are using a BT scanner directly connected to a host through a BT dongle, verify that
the scanner and the BT driver used by the dongle share the same PIN code and the same
security level. Otherwise the connection cannot be established.
NOTE
Follow these steps to set the PIN code for a scanner:
1. Enable
2. Select a PIN code length of either 4 or 16 characters by scanning the
appropriate bar code in
3. Scan the relevant bar code from
desired alphanumeric characters from the keypad in
to set the PIN code.
See page 308
this feature.

BT Security Mode

This feature enables/disables authentication and encryption of the BT link. Use
the feature
cate the BT Link.
DEFAULT
BT Security Mode = Enable
268

BT SECURITY FEATURES

BT Security Mode by scanning the "Enable" bar code below.
in "References" for more detailed information and examples for
"BT Pin Code" on page 269 to specify the PIN code used to authenti-
Changing the security mode setting will unlink the devices. If the
Automatic Configuration Update is set to the default "Enabled" set-
ting, the devices must only be relinked. If the Automatic Configuration
NOTE
Update is set to "Disabled," the Security Mode setting must also be
updated in the Base Station using Aladdin. After the Base Station has
been updated, the devices must be relinked.
"Select PIN Code Length"
"Set PIN Code"
BT Security Mode = Disable
QuickScan™ I QM21X1 / QBT21X1
Enter/Exit Programming Mode
on page 269.
on page 269, then scan the
Appendix D, Keypad