Keyboard Wedge; Wedge Quiet Interval - Datalogic QuickScan I QM21X1 Product Reference Manual

Keyboard Wedge

Wedge Quiet Interval

This option specifies the amount of time to look for keyboard activity before
the reader breaks the keyboard connection in order to transmit data to host.
The selectable range for this feature is from 0 to 990ms in 10ms increments.
NOTE
Follow these instructions to set this feature:
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the
result with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05,
20 = 20, etc.
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
ming Mode.
4. Scan the bar code: SELECT WEDGE QUIET INTERVAL SETTING.
5. Scan the appropriate two digits from the keypad in
represent the duration which was determined in the steps above. You will
hear a two-beep indication after the last character.
NOTE
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
Mode.
This completes the procedure to set the Wedge Quiet Interval. See
some examples of how to set this feature.
Table 12. Timeout Setting Examples
STEP ACTION
1 Desired Setting
Divide by 10 (and pad with
2
leading zeroes)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT WEDGE QUIET INTERVAL SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
This feature applies ONLY to the Keyboard Wedge interface.
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
EXAMPLES
10ms
01
'0' and '1'
Appendix D,
150ms 600ms
15 60
'1' and '5' '6' and '0'
Keyboard Wedge
Keypad, that
Table 17 for
850ms
85
'8' and '5'
285