Enable Character - Datalogic QuickScan I QM21X1 Product Reference Manual

Enter/Exit Programming Mode

Enable Character

Specifies the value of the RS-232 host command used to enable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected. See
Character"
NOTE
Select Enable Character Setting
40
on page 284 for more detailed programming instructions.
Setting to previously defined characters such as XON, XOFF, or
host commands conflicts with normal operation of these char-
acters. 8-bit data is not recognized when the option Data Bits
on page 27 has been set as 7 Data Bits.
$CR2EC
DEFAULT
0x45 = Enable Character is 'E'
Enable Character
QuickScan™ I QM21X1 / QBT21X1
"Enable