Configuring Auto-Tunnel Mesh Tunnel Id - Cisco ASR 9000 Series Configuration Manual

Configuring Auto-Tunnel Mesh Tunnel ID

Related Topics
Path Option Attributes, on page 151
Configuration Hierarchy of Path Option Attributes, on page 151
Traffic Engineering Bandwidth and Bandwidth Pools, on page 152
Path Option Switchover, on page 152
Path Option and Path Protection, on page 153
Configuring Auto-Tunnel Mesh Tunnel ID
Perform this activity to configure the tunnel ID range that can be allocated to Auto-tunnel mesh tunnels.
SUMMARY STEPS
1. configure
2. mpls traffic-eng
3. auto-tunnel mesh
4. tunnel-id min value max value
5. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2
mpls traffic-eng
Example:
RP/0/RSP0/CPU0:router(config)# mpls
traffic-eng
Step 3
auto-tunnel mesh
Example:
RP/0/RSP0/CPU0:router(config-mpls-te)#
auto-tunnel mesh
Step 4 tunnel-id min value max value
Example:
RP/0/RSP0/CPU0:router(config-te-auto-mesh)#
tunnel-id min 10 max 50
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
244
Purpose
Enters global configuration mode.
Enters MPLS TE configuration mode.
Enters auto-tunnel mesh configuration mode. You can configure
auto-tunnel mesh related options from this mode.
Specifies the minimum and maximum number of auto-tunnel mesh
tunnels that can be created on this router. The range of tunnel ID
is from 0 to 65535.
Implementing MPLS Traffic Engineering
OL-28381-02