Configuring The Pseudowire - Cisco ASR 9000 Series Configuration Manual

Implementing MPLS Transport Profile
Command or Action
Step 3
pw-class name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# pw-class
foo
Step 4
encapsulation mpls
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-pwc)#
encapsulation mpls
Step 5 preferred-path interface tunnel-tp tunnel-number
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-pwc-mpls)#
preferred-path interface tunnel-tp 10
Step 6 Use the commit or end command.

Configuring the Pseudowire

Perform this task to configure the pseudowire.
SUMMARY STEPS
1. configure
2. interface type interface-path-id
3. pseudowire-class class-name
4. encapsulation mpls
5. preferred-path interface tunnel-tp tunnel-number
6. Use the commit or end command.
OL-28381-02
Purpose
Creates a pseudowire OAM class named foo and enters
pseudowire OAM class configuration mode.
Sets pseudowire encapsulation to MPLS.
Specifies TP tunnel interface 10 for the preferred-path.
commit—Saves the configuration changes and remains within
the configuration session.
end—Prompts user to take one of these actions:
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
Configuring the Pseudowire
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
321