Configuring Explicit Paths With Abrs Configured As Loose Addresses - Cisco ASR 9000 Series Configuration Manual

Implementing MPLS Traffic Engineering
Command or Action

Configuring Explicit Paths with ABRs Configured as Loose Addresses

Perform this task to specify an IPv4 explicit path with ABRs configured as loose addresses.
SUMMARY STEPS
1. configure
2. explicit-path name name
3. index index-id next-address [loose] ipv4 unicast ip-address
4. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2
explicit-path name name
Example:
RP/0/RSP0/CPU0:router(config)# explicit-path
name interarea1
Step 3
index index-id next-address [loose] ipv4 unicast
ip-address
Example:
RP/0/RSP0/CPU0:router(config-expl-path)#
index 1 next-address loose ipv4 unicast
10.10.10.10
OL-28381-02
Configuring Explicit Paths with ABRs Configured as Loose Addresses
Purpose
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
Purpose
Enters global configuration mode.
Enters a name for the explicit path.
Includes an address in an IP explicit path of a tunnel.
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
191