Configuring Ldp Discovery For Targeted Hellos: Example; Configuring Label Advertisement (Outbound Filtering): Example - Cisco ASR 9000 Series Configuration Manual

Implementing MPLS Label Distribution Protocol
show mpls ldp discovery
Related Topics
Configuring LDP Discovery Over a Link, on page 22
LDP Control Plane, on page 6

Configuring LDP Discovery for Targeted Hellos: Example

The examples show how to configure LDP Discovery to accept targeted hello messages.
Active (tunnel head)
mpls ldp
router-id loopback0
interface tunnel-te 12001
!
!
Passive (tunnel tail)
mpls ldp
router-id loopback0
discovery targeted-hello accept
!
Related Topics
Configuring LDP Discovery for Active Targeted Hellos, on page 24
Configuring LDP Discovery for Passive Targeted Hellos, on page 26
LDP Control Plane, on page 6

Configuring Label Advertisement (Outbound Filtering): Example

The example shows how to configure LDP label advertisement control.
mpls ldp
!
ipv4 access-list pfx_acl_1
!
ipv4 access-list pfx_acl_2
!
ipv4 access-list peer_acl_1
OL-28381-02
label
advertise
disable
for pfx_acl_1 to peer_acl_1
for pfx_acl_2 to peer_acl_2
for pfx_acl_3
interface POS 0/1/0/0
interface POS 0/2/0/0
!
!
10 permit ip host 1.0.0.0 any
10 permit ip host 2.0.0.0 any
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
Configuring LDP Discovery for Targeted Hellos: Example
53