Cisco ASR 9000 Series Configuration Manual page 301

Implementing GMPLS UNI
SUMMARY STEPS
1. configure
2. mpls traffic-eng
3. gmpls optical-uni
4. controller dwdm interface
5. tunnel-properties
6. priority setup-priority hold-priority
7. record-route
8. signalled-name name
9. logging events lsp-status state
10. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2 mpls traffic-eng
Example:
RP/0/RSP0/CPU0:router(config)# mpls
traffic-eng
Step 3 gmpls optical-uni
Example:
RP/0/RSP0/CPU0:router(config-mpls-te)# gmpls
optical-uni
Step 4 controller dwdm interface
Example:
RP/0/RSP0/CPU0:router(config-te-gmpls)#
controller dwdm 0/1/0/1
Step 5 tunnel-properties
Example:
RP/0/RSP0/CPU0:router(config-te-gmpls-cntl)#
tunnel-properties
OL-28381-02
Purpose
Enters global configuration mode.
Enters MPLS-TE configuration mode.
Enters GMPLS UNI configuration submode.
Enters GMPLS UNI controller submode.
Enters the submode to configure tunnel-specific information for
a GMPLS UNI controller.
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
Configuring TE for GMPLS UNI
285