Configuring Mpls-Tp Lsp Wrapping - Cisco ASR 9000 Series Configuration Manual

Configuring MPLS-TP LSP Wrapping

DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2 mpls traffic-eng
Example:
RP/0/RSP0/CPU0:router(config-mpls-te)#
mpls traffic-eng
Step 3 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-mpls-te)#
interface POS 0/6/0/0
Step 4 link-id value next-hop address
Example:
RP/0/RSP0/CPU0:router(config-mpls-te-if)#
link-id 22 next-hop 10.1.1.2
Step 5
Use the commit or end command.
Configuring MPLS-TP LSP Wrapping
Perform this task to configure the MPLS-TP LSP wrapping.
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
328
Purpose
Enters global configuration mode.
Enters MPLS TE configuration mode.
Configures an interface type and path ID to be associated with a MPLS
TE mode.
Configures an interface type and path ID to be associated with a MPLS
TE mode.
You must provide the next-hop IP
Note
address.
You can define a link ID once. If you attempt to use the same
Note
MPLS-TP link ID with different interface or next-hop address,
the configuration gets rejected. You have to remove the
existing link ID configuration before using the same link ID
with a different interface or next-hop address.
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
Implementing MPLS Transport Profile
OL-28381-02