Configuring Ldp Igp Synchronization: Isis - Cisco ASR 9000 Series Configuration Manual

Configuring LDP IGP Synchronization: ISIS

DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2 router ospf process-name
Example:
RP/0/RSP0/CPU0:router(config)# router ospf
100
Step 3 Use one of the following commands:
• mpls ldp sync
• area area-id mpls ldp sync
• area area-id interface name mpls ldp sync
Example:
RP/0/RSP0/CPU0:router(config-ospf)# mpls ldp
sync
Step 4 Use the commit or end command.
Related Topics
IGP Synchronization, on page 16
Configuring LDP IGP Synchronization—OSPF: Example, on page 56
Configuring LDP IGP Synchronization: ISIS
Perform this task to configure LDP IGP Synchronization under ISIS.
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
40
Implementing MPLS Label Distribution Protocol
Purpose
Enters global configuration mode.
Identifies the OSPF routing process and enters OSPF configuration
mode.
Enables LDP IGP synchronization on an interface.
commit—Saves the configuration changes and remains within
the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
OL-28381-02