Configuring Tunnel Attribute-Set Templates - Cisco ASR 9000 Series Configuration Manual

Configuring Tunnel Attribute-Set Templates

Command or Action
Step 7
destination-list
Example:
RP/0/RSP0/CPU0:router(config-mpls-te-auto-mesh-group)#
destination-list dl-65
Step 8 Use the commit or end command.
Related Topics
Auto-Tunnel Mesh, on page 153
Destination List (Prefix-List), on page 154
Configuring Tunnel Attribute-Set Templates
Perform this task to define attribute-set templates for auto-mesh tunnels.
SUMMARY STEPS
1. configure
2. mpls traffic-eng
3. attribute-set auto-mesh attribute-set-name
4. affinity value mask mask-value
5. signalled-bandwidth kbps class-type class-type number
6. autoroute announce
7. fast-reroute protect bandwidth node
8. auto-bw collect-bw-only
9. logging events lsp-status {state | insufficient-bandwidth | reoptimize | reroute }
10. Use the commit or end command.
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
248
Implementing MPLS Traffic Engineering
Purpose
This is a mandatory configuration under a meshgroup.
If a given destination-list is not defined as a prefix-list,
this meshgroup create tunnels to all nodes available in
TE topology.
commit—Saves the configuration changes and remains
within the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration mode,
without committing the configuration changes.
OL-28381-02