Implementing GMPLS UNI
Configuring an LMP Neighbor
Perform this task to configure an LMP neighbor for a GMPLS UNI tunnel.
SUMMARY STEPS
1. configure
2. lmp
3. gmpls optical-uni
4. neighbor name
5. ipcc routed
6. router-id ipv4 unicast address
7. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2
lmp
Example:
RP/0/RSP0/CPU0:router(config)# lmp
Step 3
gmpls optical-uni
Example:
RP/0/RSP0/CPU0:router(config-lmp)# gmpls optical-uni
Step 4
neighbor name
Example:
RP/0/RSP0/CPU0:router(config-lmp-gmpls-uni)# neighbor
nbr1
Step 5
ipcc routed
Example:
RP/0/RSP0/CPU0:router(config-lmp-gmpls-uni-nbr-nbr1)#
ipcc routed
OL-28381-02
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
Configuring LMP for GMPLS UNI
Purpose
Enters global configuration mode.
Enters LMP configuration mode.
Enters GMPLS UNI configuration submode.
Specifies an LMP neighbor for GMPLS and enters
LMP GMPLS UNI neighbor configuration submode.
Specifies the LMP neighbor IPCC configuration for
GMPLS UNI.
291