Section 4 How To Exit Programming Mode; Section 5 Using Keys To Move Around In The Programs; Table 1-1 Keys For Entering Data - NEC SL100 Programming Manual

ISSUE 1.1
S 4 HOW TO EXIT PROGRAMMING MODE
ECTION
To-exit the programming mode :
When you are done programming, you must be out of a program option to exit (pressing the Mute key
will exit the program option).
1 Press Mute key to exit the program options, if needed.
2 Press Speaker. If changes were to the system programming, "Saving System Data" is displayed.
3 The display shows "Complete Data Save" when completed and exits the telephone to an idle
mode.
To save a customer's database, a blank Compact Flash (CF) Card is required. Insert the CF Card into the CPU
and, using Program 90-03, save the software to the CF Card. (Program 90-04 is used to reload the customer
data if necessary.) Note that a CF Card can only hold one customer database. Each database to be saved re-
quires a separate drive.
S 5 USING KEYS TO MOVE AROUND IN THE
ECTION
PROGRAMS
Once you enter the programming mode, use the keys in the following chart to enter data, edit data and
move around in the menus.
When you want to ...
Enter Data into program
Next Index
Prior Index
Select Data
Programming Manual
Program Mode
CF card
CPU card

Table 1-1 Keys for Entering Data

0 ~ 9,
Cursor Key (Up)
Cursor Key (Down)
Line Key (1 ~ 6)
CF Slot (CN2)
VMDB-C1
Telephone Programming
, #, Line Key (1 ~ 6)
*
SL1000
1-3