Analog Trunk Data Setup - NEC SL100 Programming Manual

ISSUE 1.1
Level
IN
Description
Use Program 14-02 : Analog Trunk Data Setup to set the basic options for each analog trunk port.
Refer to the table below for a description of each option, its range and default setting.
Input Data
Trunk Port Number
Item
Item
No.
01 Signaling Type (DP/DTMF)
This option sets the signaling
type for the trunk.
02 Ring Detect Type
This option sets Extended Ring
Detect or Immediate Ring De-
tect for the trunk. For T1 loop/
ground start trunks, this option
must be set to 1 for the trunks
to ring and light correctly.
03 Flash Type
This option selects the flash
type (open loop flash or
ground). Always set this option
for open loop flash.
04 Hooking Type
This option lets you use Flash
for Timed Flash (Program 81-
01-14) or Disconnect (Program
81-01-15). (A user implements
Flash by pressing the FLASH
key while on a trunk call.)
05 Dial Tone Detection for Manu-
ally Accessed Trunks
Use this option enable/disable
dial tone detection for directly
accessed trunks. If disabled,
the system outdials on the
trunks without monitoring for
dial tone.
06 Pause at 1st Digit after Line
Seize in Manual Dial Mode
Programming Manual
Program 14 : Trunk, Basic Setup

14-02 : Analog Trunk Data Setup

Input Data
0 = Dial Pulse (10 PPS)
2 = DTMF
0 = Normal/delayed
1 = Immediate Ringing
0 = Open Loop Flash
1 = Ground
0 = Timed Flash (Hooking)
1 = Disconnect (Cut)
0 = Dial Tone Detection
Not Used
1 = Dial Tone Detection
Used
0 = No Pause (No)
1 = Pause (Yes)
001 ~ 126
Related Pro-
Default
gram
2
0
0
1 81-01-14
81-01-15
1 21-01-04
1 21-01-06
SL1000
Program
14
Note
2-99