Section 6 Programming Names And Text Messages; Table 1-2 Keys For Entering Names - NEC SL100 Programming Manual

SL1000
When you want to ...
All Clear
Register
Go Back to Prior Screen
Move Cursor Jump Up/Down
Delete single character
Next Page
Toggle between Number/Character
While in a Entering Number
Prior Page
Quit the programming
Move Cursor to Left
Change Program Number
Change Index Number
Change Program Number
Change Index Number
Move Cursor to Right
S 6 PROGRAMMING NAMES AND TEXT MESSAGES
ECTION
Several programs (e.g., Program 20-16 : Selectable Display Messages) require you to enter text. Use
the following chart when entering and editing text. When using the keypad digits, press the key once
for the first character, twice for the second character, etc. For example, to enter a C, press the key 2
three times. Press the key six times to display the lower case letter. The name can be up to 12 digits
long.
Use this keypad digit ...
1
2
3
4
5
6
7
8
9
0
*
#
1-4
Flash
Hold
Enter
Mute
Clear / Back
DND (V1.5 Added) or DND / CONF
Clear / Back
-
Help
-
Speaker
Exit
Cursor Key (Left)
-
-
Cursor Key (Right)

Table 1-2 Keys for Entering Names

Enter characters : 1 @ [ ¥ ] ^ _ ` { | }
Enter characters : A-C, a-c, 2.
Enter characters : D-F, d-f, 3.
Enter characters : G-I, g-i, 4.
Enter characters : J-L, j-l, 5.
Enter characters : M-O, m-o, 6.
Enter characters : P-S, p-s, 7.
Enter characters : T-V, t-v, 8.
Enter characters : W-Z, w-z, 9.
Enter characters : 0 ! " # $ % & ' ( ) ô õ ú å ä æ ö ü α ε θ В
Enter characters : + , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
*
# = Accepts an entry (only required if two letters on the same key are needed - ex :
TOM). Pressing # again = Space. (In system programming mode, use the right arrow
Softkey instead to accept and/or add a space.)
Telephone Programming
When you want to ...
Á À Â Ã Å Æ Ç É Ê ì ó 0
ISSUE 1.1
Introduction