Lan Ipv6; Time And Date - D-Link DSL-2750E User Manual

Section 3 – Web Configuration

LAN IPv6

Choose SETUP > LAN IPv6. The page shown in the right figure appears. This
page allows you to configure IPv6 LAN.
The following table describes the parameters of this page.
Field
IPv6 Interface
Address
Enable DHCPv6
Server
LAN address
config mode
Start/End Interface
ID
DHCPv6 Lease
Time
Enable RADVD

Time and Date

Choose SETUP > Time and Date. The page shown in the right figure appears.
This page allows you to configure IPv6 LAN.
In the Time and Date page, you can configure, update, and maintain the correct
time on the internal system clock. You can set the time zone that you are in and
the network time protocol (NTP) server. You can also configure daylight saving to
automatically adjust the time when needed.
Select Automatically synchronize with Internet time servers.
Enter the specific time server and select the time zone from the corresponding
drop-down lists.
Select Enable Daylight Saving if necessary. Set the daylight as you want.
Click Apply to save the settings.
D-Link DSL-2750E User Manual
Description
The address through which PCs access the
gateway.
Choose to enable or disable DHCPv6 service.
Set the mode address obtaining mode of LAN PCs.
You may choose Stateless or Stateful.
The address pool using DHCPv6 for address
assignment under stateful mode.
The address lease time using DHCPv6 for address
assignment under stateful mode.
Choose to enable or disable router advertisement
(RADVD) service.
31