D-Link DSL-2750E User Manual page 48

Section 3 – Web Configuration
Bridge Filtering
Choose ADVANCED > Filtering Options > Bridge Filtering. The page shown
in the right figure appears. This page is used to configure bridge parameters. In
this page, you can change the settings or view some information of the bridge
and its attached ports.
Click Add to add a bridge filter. The page shown in the right figure appears.
The following table describes the parameters of this page.
Field
Protocol Type
Destination MAC
Address
Source MAC
Address
Frame Direction
Time schedule
Wan interface
Click Apply to save the settings.
D-Link DSL-2750E User Manual
Description
Choose a third-layer protocol type for bridge
filtering from the drop-down list. You may choose
PPPoE, IPv4, IPv6, AppleTalk, IPX, or NetBEUI.
The MAC address of sendee of the message.
The MAC address of sender of the message.
Choose the sending direction as WAN to LAN or
LAN to WAN.
Choose the filtering strategy as always or never.
Set an effective interface for the bridge filtering
rule.
46