D-Link DSL-2750E User Manual page 65

Section 3 – Web Configuration
Services
Choose MANAGEMENT > Access Controls > Services. The page shown in
the right figure appears.
In this page, you can enable or disable the services that are used by the remote
host. For example, if telnet service is enabled and port is 23, the remote host can
access the device by telnet through port 23. Normally, you need not change the
settings.
Select the management services that you want to enable or disable on the LAN
or WAN interface. Click Apply to apply the settings.
Note:
If you disable HTTP service, you cannot access the configuration page of
the device any more.
IP Address
Choose MANAGEMENT > Access Controls > IP Address. The page shown in
the right figure appears.
In this page, you can configure the IP address for access control list (ACL). If
ACL is enabled, only devices with the specified IP addresses can access the
device.
Select Enable Access Control Mode to enable ACL.
Note:
If you enable the ACL, ensure that IP address of the host is in the ACL
list.
D-Link DSL-2750E User Manual 63