D-Link DSL-2750E User Manual page 57

Section 3 – Web Configuration
Policy Route
Choose ADVANCED > Routing > Policy Route. The page shown in the right
figure appears. The policy route binds one WAN connection and one LAN
interface.
Click add, the page shown in the right figure appears. Choose one WAN
connection and at least one LAN connection to bind together, and then click
Apply to finish the settings.
Default Gateway
Choose ADVANCED > Routing > Default Gateway. The page shown in the
right figure appears. You may assign a default gateway for the router to use first.
Click Apply to save the settings.
RIP
Choose ADVANCED > Routing > RIP. The page shown in the right figure
appears. This page is used to select the interfaces on your device that use RIP
and the version of the protocol used.
RIPng
Choose ADVANCED > Routing > RIPng. The page shown in the right figure
appears. In this page, you may choose an interface and active RIPng for it.
Click Apply to save the settings.
D-Link DSL-2750E User Manual 55