D-Link DSL-2750E User Manual page 29

Section 3 – Web Configuration
Note:
A mobile phone cannot be connected to the wireless network by scanning
QRcode unless installing QRcode software.
Wireless Security
Choose SETUP > Wireless > Wireless Security. The page shown as the right
figure appears. In this page, you can configure the parameters of wireless LAN
clients that may connect to the device. Wireless security is vital to your network
to protect the wireless communication among wireless stations, access points
and wired network.
The default security mode is None. If the security mode is set to None, your
wireless network can be connected by all wireless clients that can detect the
SSID of this network.
If the Security Mode is set to Auto(WPA or WPA2), WPA only, or WPA2 only,,
the page is shown as the right figure appears. Take Auto(WPA or WPA2) as an
example.
Step 1 In Security Mode drop-down list, select Auto(WPA or WPA2).
Step 2 In WPA Encryption drop-down list, select TKIP+AES.
Step 3 Configure the WPA Mode.
- Auto(WPA or WPA2)-PSK: WPA-PSK does not require an
authentication server. You need to set a Pre-shared Key (wireless
network password) for your wireless network.
D-Link DSL-2750E User Manual 27