D-Link DSL-2750E User Manual page 39

Section 3 – Web Configuration
be connected.
5) Click Apply to start wireless connection via WPS.
- Based on the PIN of the DSL-2750E.
1) Select Enabled to enable WPS.
2) In select Mode drop-down list, select Registrar.
3) In Configuration State drop-down list, select Unconfigured.
4) Input the Generate PIN at wireless client to be connected.
5) Click Apply to start wireless connection via WPS.
WDS Setting
Choose ADVANCED > Advanced Wireless > WDS Setting. The page shown in
the right figure appears. In this page, you can set WDS to make the WLAN signal
cover more area.
D-Link DSL-2750E User Manual 37