Page 1
Technical Support Setup Procedure FAQ : Configuring PPPoE Connection with WPA Encryption using the Setup Wizard Release date : 27/05/2013 Model Support : DSL-2750E H/W: T1 S/W:1.04 FAQ: Configuring PPPoE Connection with WPA Encryption using the Setup Wizard – Version 1.00...
Page 9
Step 1: Open a web browser such as Internet Explorer, Mozilla Firefox, Safari and etc. On the Address bar, enter the LAN IP Address of the DSL-2750E. The default ip address is 192.168.1.1. Press ‘Enter’ key on your keyboard. Please enter the new ip address of the router if you have changed it.
Page 10
-10- Step 3: You are now at the DSL-2750E web interface. Click on the SETUP tab, select Wizard on the left. Under INTERNET CONNECTION WIZARD, click on the Setup Wizard button. Step 4: This wizard will guide you through a step-by-step process to configure your DSL-2750E to connect to the Internet.
Page 11
-11- Step 5: From this section, you can enable or disable Daylight Saving and set the time zone that you are in and set the NTP (Network Time Protocol) Server. You can also adjust the time through 'Manual setup time' when needed. Click Next to continue. FAQ: Configuring PPPoE Connection with WPA Encryption using the Setup Wizard –...
Page 12
-12- Step 6: The next step is to Setting up the Internet Connection, configure the following; 1. Country: Select the country where you are currently located 2. ISP (Internet Service Provider): Select from the drop down box the name of the service provider who provide the Internet Connection 3.
Page 13
-13- Step 7: The next step is to Setting up the Wireless Network, configure the following; 1. Put a check mark on Enable Your Wireless Network 2. Enter your desired name (SSID) for the Wireless Network 3. Select WPA-PSK or WPA2-PSK on the Security Level 4.
Page 14
-14- Step 8: The factory default password of this router is admin. To help secure your network, D-Link recommends that you should choose a new password. If you do not wish to choose a new password now, just click "Skip" to continue. Click "Next" to proceed to next step.
Page 15
-15- Step 9: Setup is now completed, click on the Apply button to save the settings. FAQ: Configuring PPPoE Connection with WPA Encryption using the Setup Wizard – Version 1.00...