Local Network - D-Link DSL-2750E User Manual

Section 3 – Web Configuration

Local Network

You can configure the LAN IP address according to the actual application. The
preset IP address is 192.168.1.1. You can use the default settings and DHCP
service to manage the IP settings for the private network. The IP address of the
device is the base address used for DHCP. To use the device for DHCP on your
LAN, the IP address pool used for DHCP must be compatible with the IP address
of the device. The IP address available in the DHCP IP address pool changes
automatically if you change the IP address of the device.
You can also enable the secondary LAN IP address. The two LAN IP addresses
must be in different networks.
Choose SETUP > Local Network. The Local Network page shown in the right
figure appears.
To configure the local network of 2750E, do as follow:
Step 1 In the Router IP Address textbox, enter the IP address of LAN
interface. The default IP address is 192.168.1.1. The Router IP
address is the URL address for logging in the Web configuration page.
Step 2 Enter the subnet mask of LAN interface. If the Router IP address is
192.168.1.1, the range of subnet mask is from 255.255.0.0 -
255.255.255.254.
Step 3 In the Domain Name textbox, set a domain name. If you leave it blank,
a domain name assigned by DHCP from the ISP is used.
Step 4 Select Configure the second IP Address and Subnet Mask for
LAN. It enables the secondary LAN IP address for your router. It will
be used when your primary router IP address is in the same network
segment with other LANs. The Secondary router IP address must be in
the different network segment from the primary one.
Step 5 Enter the secondary router IP address and subnet mask.
Step 6 Configure DHCP Server.
- Enable DHCP Relay: Enable the message to transmit between
clients in different network segment.
- Enable DHCP Server: Enable the router to assign IP addresses, IP
default gateway and DNS Servers to the host.
D-Link DSL-2750E User Manual 29