D-Link DSL-2750E User Manual page 61

Section 3 – Web Configuration
The following table describes the parameters of this page.
Field
Tunnel Name
Tunnel Mode
Wan Interface
Lan Interface
Click Apply to enable the settings.
Click Add below the table DS-Lite IPv4 over IPv6 Tunnel List to add a DS-Lite
item, which is a 4in6 tunnel.
The following table describes the parameters of this page.
Field
Mechanism
Dynamic
RemoteI v6Addres
s
Configure 6in4 Tunnel
Choose ADVANCED > IP Tunnel > Configure 6in4 Tunnel. The page shown in
the right figure appears. In this page, you can configure IPv6 penetration through
IPv4 network. When only IPv4 access is provided by your ISP, you can access
the Internet via IPv4 and IPv6.
Click Add below the table IPTUNNEL to add tunnel items.
The following table describes the parameters of this page.
Field
Tunnel Name
Tunnel Mode
Wan Interface
Lan Interface
Click Apply to enable the settings.
D-Link DSL-2750E User Manual
Description
Set a tunnel name.
Select the tunnel mode as 4 in6 or 6in4.
Choose a WAN interface used for the tunnel.
Choose a LAN interface used for the tunnel.
Description
The tunnel type is DS-Lite, which is 4in6 tunnel.
Set the obtaining mode of remote IPv6
addresses. You can select 0 or 1.
Set the remote end IPv6 address of the tunnel.
Description
Set a tunnel name.
Select the tunnel mode as 4 in6 or 6in4.
Choose a WAN interface used for the tunnel.
Choose a LAN interface used for the tunnel.
59