Wireless - D-Link DSL-2750E User Manual

Section 3 – Web Configuration
Adding a WAN access in other modes.
To add a WAN access in other modes, select the corresponding protocol and
input the information provided by your ISP.

Wireless

This section describes the configuration of 2.4G wireless network.
Choose SETUP > Wireless. The page shown in the right figure appears. This
section contains Wireless Basic and Wireless Security.
Wireless Basic
Choose SETUP > Wireless > Wireless Basic. The page shown as the right
figure appears. In this page, you can configure the parameters of wireless LAN
clients that may connect to the device.
To configure this page, do as follow:
Step 1 Select Enable Wireless.
Step 2 Select Enable MultiAP Isolation. After isolate multiAP, the wireless
clients connected to the DSL-2750E cannot communicate with each
other.
Step 3 In Wireless Network Name (SSID) textbox, enter a name for your
wireless network. You can also keep it as defaults.
Step 4 Configure Visibility Status.
- Select Visible, your SSID can be detected by wireless clients
automatically.
- Select Invisible, the SSID cannot be detected by wireless clients.
Step 5 In Country/Region drop-down list, select the country you locate.
Step 6 Keep other entries as defaults.
Click Apply to save the settings.
There is a QRcode on the right of the page. This QRcode can help your mobile
phone connect to the wireless network of DSL-2750E automatically by scan the
QRcode with this mobile phone.
D-Link DSL-2750E User Manual 26