D-Link DSL-2750E User Manual page 20

Section 3 – Web Configuration
Static IP
-
If the protocol is set to Static IP, the page shown as the right figure appears.
You can set the parameters in this page as follow:
1) Set the protocol to Static IP.
2) Choose the Encapsulation Mode provided by your ISP.
3) Enter the VPI and VCI provided by your ISP.
4) Enter the WAN IP Address, Subnet Mask, Default Gateway, and Primary
DNS Server provided by your ISP.
- Dynamic IP/Bridge
If the protocol is set to Dynamic IP/Bridge, the page shown as the right figure
appears.
In this page, enter the connection type, VPI, and VCI provided by your ISP.
After setting, click Next.
D-Link DSL-2750E User Manual 18