Table of Contents
Advertisement
EASY LOUDNESS
Set up GUI – INTERFACES – SDI I/O interface – Local Routing
The SDI interface comes with a local routing matrix to shuffle audio signals from and to the system (device)
and from and to the physical de-embedders / embedders.
The example below shows a routing that sends signals 1:1 from the physical de-embedders
[INTERFACE – SDI
[SYSTEM – SDI DE-Embedder: DEM1 ... DEM16] and the signals from the device
[SYSTEM – SDI Embedder: EMB 1 ... EMB16] are sent to physical Embedders
SDI OUT G1 CH1 ... SDI OUT G4 CH4]:
Important Note! The matrix display is a generic view generated by the SDI interface.
For the EASY LOUDNESS application the SYSTEM labels are translated in pairs:
DEM 1/2 to SDI 1/2 ... DEM 15/16 to SDI 15/16
EMB 1/2 to SDI 1/2 ... EMB 15/16 to SDI 15/16
If you must shuffle SDI signals to meet a certain output signal assignment you can do it with the above
matrix. E.g. you may shuffle SDI IN G2 CH1/2 to SDI OUT G4 CH3/4.
IN: SDI IN G1 CH1 ... SDI IN G4 CH4] to the device inputs
23
[INTERFACE - SDI
OUT:
Advertisement
Table of Contents
