Table of Contents
Advertisement
EASY LOUDNESS
Setup GUI – connecting with the EASY LOUDNESS
You must open a browser and enter the IP address of the EASY LOUDNESS
into the URL field
Home page:
The entrance pane is the HOME page. If you are returning from other pages or if you reload your browser
content (by pressing <F5>) it may show a different page due to the caching of the browser.
In the top section you see several bar graph displays for signal levels as well as for gain reduction display
of function blocks.
On the following pages we will go through the various panes to show you the basic setup of the device.
You may set up the synchronization source. You may also give the device a name, tell it its location and
define an administrative contact which may be used by the monitoring system of your house (e.g. via SNMP).
You may change settings of the installed interface module and the signal routing.
and press <Enter>. The browser will retrieve the necessary information and open up the
9
Advertisement
Table of Contents
