Konica Minolta CL-70F Operating Manual page 85

6.
Press the Measuring Button 5.
Measurement will be taken with flash, and the light source values will be
displayed.
ecause it affects measurement while measuring, the LC bac light will dim. This is normal.
Measurement in Cord (PC) Flash Mode is complete.
CAUTION
●
Depending on the flash e uipment used, the flash may be triggered when the
sync cord is connected to the Sync Terminal
Button . Because there is the possibility of burns or negative effects on
3
vision, please handle with care.
●
Do not trigger flash while skin or other objects are in contact with the flash
tube. Do not touch the flash tube after continuous flashes. (It may cause burns.)
●
Do not trigger flash while near the eyes of people or animals. (It may
temporarily affect vision.)
●
The flash may be triggered suddenly. Because there is the possibility of
burns or negative effects on vision, please handle with care.
NOTICE
● If the triggering voltage of the flash used is extremely low, the flash may not
trigger. In this care, use "5-3 Measurement in Cordless Flash Mode". ( P65)
● In the Cordless Flash mode, the measured color temperature may change
depending on the shutter speed set for flash measurement and the amount of
ambient light present when the measurement is made.
NOTE
ver or nder will be displayed if the light source illumination is too bright or not bright enough,
or if the color temperature is out of the measurement range, when the Measuring utton is pressed.
When the color temperature is outside the calculation range, --- is displayed.
In this case, ad ust the brightness or color temperature of light source, or switch the light
range. ( P78)
5. Measuring Light Sources [Measurement Screen]
or when operating the Power
b
72