Table of Contents
Advertisement
4.
Confirm the light measuring range.
When you return to the Measurement screen,
select Range L
(
depending on the brightness of the flash.
NOTE
● Range L
(
lower than
Range H.
● Range H
than
0l s)
5.
Press the Measuring Button 5.
The meter will enter measurement standby mode.
While the icon is blinking, manually trigger the flash.
The [Measuring Mode] icon will blink for 90 seconds when measuring.
The display panel illumination will dim when the Measuring utton is pressed as the
display illumination can affect the reading. This is normal.
When the flash light is fired, the measured value will be displayed for
the display will return to measurement standby mode.
To cancel standby mode, touch the screen or press the Menu utton
NOTE
When the icon stops blin ing before triggering the flash, or when you want to
restart the 0-second delay cycle again, press Measuring utton
Measurement in Cordless Flash Mode is complete.
) or Range H
(
) Select when measuring small and low power flash units
0l s),
ver will appear if flash power is too high. Select
(
) Select when measuring powerful flash units brighter
nder will appear if flash power is too low. Select Range L.
67
5. Measuring Light Sources [Measurement Screen]
Light Selection Ring
Range H
Range L
)
Measuring utton
2
5
seconds, and
.
6
again.
5
Hide quick links:
Advertisement
Table of Contents
