Rustic Log Set Installation/Removal - Pacific energy BRISTOL Installation And Operating Instructions Manual

Installation
1. Position rear logs #1 and #2 against the back
box as seen in Figure 71.
2. Position front logs #3 and #4 between the front
burner tubes as seen in Figure 72.
3. Position side logs #5; #6 as seen in Figure 73.
4. Position logs #7 and #8 as seen in Figure 774
5. Place logs # 9; 10 and 11 and ember chunks in
front of burner to hide the burner as seen in Figure
75.
Note: Do Not Block Burner Ports with
Embers
Removal
1. Remove embers from replace.
2. Lift the side and decorative log off of the front log
and remove it from the rebox.
3. Lift the front logs off of the burner and remove it
from the rebox.
4. Lift the rear logs over the pilot and burner and
remove from rebox.
Figure 70: Log Set
Figure 71: Rear Log Installation
BRSL.BODYB
140515-44
BDFD.BODYB
Rustic Log Set Installation / Removal
re-
Figure 72: Front Log Installation
Figure 73: Side Log Installation
Figure 74: Decorative Log Installation
Figure 75: Complete Log Set
35
INSTALLER
INFORMATION
5055.633-B