Pacific energy BROADWAY GBWY.BODYA Installation And Operating Instructions Manual
Pacific energy BROADWAY GBWY.BODYA Installation And Operating Instructions Manual

Pacific energy BROADWAY GBWY.BODYA Installation And Operating Instructions Manual

Hide thumbs Also See for BROADWAY GBWY.BODYA:

Advertisement

Quick Links

INSTALLER:
Leave this manual with the appliance.
CONSUMER:
Retain this manual for future reference.
WARNING:
If the information in these
instructions is not followed exactly a fire or
explosion may result causing property
damage, personal injury or death.
FOR YOUR SAFETY
Do not store or use gasoline or other
flammable vapours and liquids in the vicinity
of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
 Do not try to light any appliance.
 Do not touch any electrical Switch.
 Do not use any phone in your building.
 Immediately call your gas supplier
from a neighbour's phone. Follow the
gas supplier's instructions.
 If you cannot reach your gas supplier
call the fire department.
Installation and service must be performed
by a qualified installer, service agency or the
gas supplier.
This appliance may be installed in an
aftermarket permanently located,
manufactured home (USA only) or mobile
home, where not prohibited by local codes.
This appliance is only for use with the type of
gas indicated on the rating plate. This
appliance is not convertible for use with
other gases unless a certified kit is used.
This appliance is suitable for installation in a
bedroom or bed sitting room.
080913
BROADWAY & BRENTWOOD
INSTALLATION AND

OPERATING INSTRUCTIONS

MODEL:
BROADWAY GBWY.BODYA
&
BRENTWOOD GBNT.BODYA
FIREPLACE INSERT
GBWY.BODYA / GBNT.BODYA
5055.66

Advertisement

Table of Contents
loading

Summary of Contents for Pacific energy BROADWAY GBWY.BODYA

  • Page 1: Operating Instructions

    This appliance is not convertible for use with MODEL: other gases unless a certified kit is used. BROADWAY GBWY.BODYA This appliance is suitable for installation in a & bedroom or bed sitting room. BRENTWOOD GBNT.BODYA...
  • Page 2: Table Of Contents

    Table Of Contents Caution..............3 Safety..............4 Owners Information First Fire...............5 Remote control.............6 Maintenance............12 Lighting Instructions...........13 Installer information Commonwealth of Massachusetts.....14 Fireplace Dimensions........15 Existing Fireplace Preparation......16 Clearances to Combustibles......17 Venting...............18 Plumbing and Electrical........19 Gas Supply............20 Gas Pressure Check / Output / Efficiency..20 Gas Pressure Testing Procedure.......21 Pilot Adjustment..........21 Propane Conversion..........22...
  • Page 3: Caution

    Caution FOR YOUR SAFETY - Do not install or operate your Pacific Energy appliance without first reading and understanding this manual. Any installation or operational deviation from the following instructions voids the Pacific Energy Warranty and may prove hazardous. This appliance and its individual shut off valve must be disconnected from gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 psig (3.5 kPa).
  • Page 4: Safety

    Safety  Due to high temperatures, this gas appliance should be located out of traffic and away from furniture and draperies.  Children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition. ...
  • Page 5: Owners Information

    OWNER’S INFORMATION Congratulations on your purchase of a Pacific Energy Gas Appliance. Your fireplace has been professionally installed by: Dealer name: ___________________ Phone Number:_________________ If you discover any problems with your gas appliance contact your dealer immediately to have the unit repaired.
  • Page 6: Remote Control

    OWNER’S Remote Control Operation INFORMATION System Description The Proflame Remote Control System consists of two elements: 1. Proflame Transmitter. 2. Proflame Integrated Fireplace Control (IFC) board and a wiring harness to connect the IFC to the gas valve and stepper motor. Transmitter (Remote Control with LCD Display) The Proflame Transmitter uses a streamline design with a simple button layout and informative LCD display (Fig.
  • Page 7: Operating Procedure

    OWNER’S INFORMATION IFC Module The Proflame 2 Integrated Fireplace Control (IFC) board is a device that allows the automatic ignition and pilot flame supervision, to command the functions of a hearth appliance. It is configured to control the ON/OFF main burner operation, giving the choice of both IPI (intermittent pilot ignition), and CPI (continuous pilot ignition) modes.
  • Page 8 OWNER’S INFORMATION Temperature indication Display With the system in the “OFF” position, press the Thermostat Key and the Mode Key at the same time. Look at the LCD screen on the transmitter to verify that a C or F is visible to the right of the Room Temperature display. (Fig.
  • Page 9 OWNER’S INFORMATION Remote Flame Control The Proflame has six (6) flame levels. With the system on, and the flame level at the maximum in the appliance, pressing the down arrow key once will reduce the flame height by one step until the flame is turned off.
  • Page 10 OWNER’S INFORMATION Comfort Fan Speed Control If the appliance is equipped with a hot air circulating fan, the speed of the fan can be controlled by the Proflame system. The fan speed can be adjusted through six (6) speeds. To activate this function use the Mode Key (fig.1) to index the fan control icon (Fig. 10). Use the Up/Down Arrow Keys (Fig.1) to turn on, off or adjust the fan speed (fig.
  • Page 11 OWNER’S INFORMATION Low Battery Power Detection Transmitter The life span of the remote control batteries depends on various factors: quality of the batteries used, the number of ignitions of the appliance, the number of changes to the room thermostat set point, etc.
  • Page 12: Maintenance

    Replacement door can be Do not substitute with any other type. obtained from your nearest Pacific Energy dealer. To remove broken glass, remove Door as noted in "Door Removal" section.
  • Page 13: Lighting Instructions

    OWNER’S Lighting Instructions INFORMATION...
  • Page 14: Installer Information

    INSTALLER INFORMATION Important Note for the Commonwealth of Massachusetts: From Massachusetts Rules and Regulations 248 CMR 5.08: For all side wall horizontally vented gas fuelled equipment installed in every dwelling, building or structure used in whole or in part for residential purposes, including those owned or operated by the Commonwealth and where the side wall exhaust vent termination is less than seven (7) feet above finished grade in the area of the venting, including but not limited to decks and porches, the following requirements shall be satisfied.
  • Page 15: Fireplace Dimensions

    INSTALLER Fireplace Dimensions INFORMATION Broadway: 14 3/4” Figure 12: Broadway Dimensions Brentwood: Figure 13: Brentwood Dimensions...
  • Page 16: Existing Fireplace Preparation

    INSTALLER Existing Fireplace Preparation INFORMATION The Broadway and Brentwood Gas inserts are certified to be installed into pre-existing approved fire place cavities. The minimum cavity requirements are listed in Figure 14 below. Dimension Broadway Brentwood 13” 15” 21” 23” 26” 34”...
  • Page 17: Clearances To Combustibles

    INSTALLER Clearances to Combustibles INFORMATION *MANTEL CLEARANCE Broadway Brentwood 20 1/2” 32” 16” 32” 11” 32” ** MANTEL DEPTH 12” 9” 6” 16” Minimum hearth depth As measured from glass Figure 15: Mantel Clearances 8” Figure 16: Sidewall Clearances...
  • Page 18: Venting

    INSTALLER Venting INFORMATION Note: The following Simpson Duravent kits are recommended for use with this appliance. High-Wind (Broadway 46DVA-CL33) (Brentwood 46DVA-CL34) Prairie Co-Linear Kit (Broadway 46DVA-CL33P) (Brentwood 46DVA-CL34P) Min..10’ (3m) Only certified venting systems or components may MAX...35’ (10.7m) be installed with this fireplace. 1) Measure chimney height, cut flex liner (min.10') as required.
  • Page 19: Plumbing And Electrical

    INSTALLER Plumbing and Electrical INFORMATION Figure 20: Gas and Electrical Connections Note: Installation requires that an electrical outlet be installed into existing fireplace cavity before insert is installed. To make the required electrical and gas connections start by positioning the gas insert within the existing fireplace.
  • Page 20: Gas Supply

    INSTALLER Gas Supply INFORMATION Servicing of the appliance can be performed from the front of the unit by removing the front trim, or by removing the gas tray from the unit. Caution: The gas line should be installed by a qualified service person in accordance with all building codes. This section is intended as a guide for qualified technicians installing this appliance.
  • Page 21: Gas Pressure Testing Procedure

    INSTALLER Gas Pressure Testing Procedure INFORMATION Note: To test the gas pressure, turn off the gas supply to the appliance before loosening test point screws. Verify gas pressures with the fireplace lit and at the highest setting. 1. Remove door (Fig. 25) and locate the valve as seen in Figure 21. 2.
  • Page 22: Propane Conversion

    INSTALLER Propane Conversion INFORMATION Before starting the conversion make sure to shut off the gas supply to the unit and allow fireplace to cool to room temperature. To convert the gas fireplace insert from natural gas to propane the (GASC.LPKIT) kit is required. This kit comes with new pilot and burner orifices as well as a new pressure modulator for the valve.
  • Page 23: Door Installation/Removal

    INSTALLER Door Installation/Removal INFORMATION Installation 1. Position the door so that the doors upper bracket is positioned overtop of the lip on top of the firebox. 2. Lower the bottom edge of the door and secure it with 1/4” bolts to the relief arms as shown in figure 25.
  • Page 24: Panel Installation/Removal

    INSTALLER Panel Installation / Removal INFORMATION Installation NOTE: Air Deflector from burner kit needs to be installed before panels. See Burner Kit Installation. 1. Insert back panel so that it is sitting on ledge at the back of the firebox as shown in Figure 28.
  • Page 25: Log Burner Kit Installation/Removal

    INSTALLER Log Burner Kit Installation / Removal INFORMATION Air Deflector Installation / Removal Installation Position the air deflector in the fireplace as seen in figure 31 and secure with two screws using a screwdriver. Removal Remove the two screws seen in figure 31 using a screwdriver, and remove the air deflector from fireplace.
  • Page 26: Log Set Installation/Removal

    INSTALLER Log Set Installation / Removal INFORMATION Installation 1. Position rear log against the back firebox as seen in Figure 33. 2. Position front log just behind the front burner tube as seen in Figure 34. 3. Position log 3 with the thin end of the log resting on top of the right end of the front log as seen in Figure 35.
  • Page 27: Glass Burner Kit Installation/Removal

    INSTALLER Glass Burner Installation / INFORMATION Removal Air Deflector Installation / Removal Installation Position the air deflector in the fireplace as seen in figure 38 and secure with two screws using a screwdriver. Removal Remove the two screws seen in figure 38 using a screwdriver, and remove the air deflector from fireplace.
  • Page 28: Replacement Parts

    INSTALLER INFORMATION Replacement Parts Description Order Number Broadway Replacement Door........... GASC.SDOORA Brentwood Replacement Door.......... GASC.LDOORA Broadway Screen............. GBWY.SCRNA Brentwood Screen............GBNT.SCRNA Complete Replacement Gas Tray........GASC.BRNTRAYA Replacement Gas Valve........... GASC.VALVEA Replacement Control Module..........GASC.MODA Replacement Pilot Assembly..........GASC.PILOTA Replacement Remote Control........... GASC.CNTRLA Broadway Aesthetic Components Brentwood Aesthetic Components...
  • Page 29: Wiring Diagram

    INSTALLER INFORMATION Caution: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.
  • Page 30: Notes

    INSTALLER INFORMATION NOTES: __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________ __________________________________________________________________________________________________...
  • Page 31 INSTALLER INFORMATION...
  • Page 32 INSTALLER INFORMATION...

This manual is also suitable for:

Brentwood gbnt.bodya

Table of Contents