Adjustable Leveling Bolts; Door Installation/Removal - Pacific energy BRISTOL Installation And Operating Instructions Manual

Adjustable leveling bolts

Figure :30 Adjustment feet on the bottom
rear of unit.
Figure 31: Door
NOTE: In the event that the door glass breaks,
The complete door assembly must be replaced.
See replacement parts list for the appropriate
part number.
BRSL.BODYB
140515-44
BDFD.BODYB
Adjustable Leveling Bolts

Door Installation/Removal

This replace comes with two leveling bolts
used to adjust the angle of the front of the
replace relative to the wall in which it's
installed. The bolts are not pre-installed and
can be found in a separate plastic bag. Care
in measuring should be exercised if using
the bolts as the replace will be required
to be removed each time an adjustment is
performed.
Installation
1. Position the door so that the doors
upper bracket is positioned overtop of
the lip on top of the rebox.
2. Lower the bottom edge of the door
and secure it with 1/4" bolts to the
relief arms as shown in Figure 31.
Removal
1. Locate and remove the two 1/4" bolts secur-
ing the bottom of door as seen in Figure 31.
2. Tilt the bottom of the door away from the
appliance and lift the door off.
23
INSTALLER
INFORMATION
5055.633-B