Log Set Installation/Removal - Pacific energy BRISTOL Installation And Operating Instructions Manual

INSTALLER
INFORMATION
Installation
1. Position rear log against the back rebox as seen
in Figure 65.
2. Position front log just behind the front burner tube
as seen in Figure 66.
3. Position log 3 with the thin end of the log resting
on top of the right end of the front log as seen in
Figure 67.
4. Place ember chunks in front of the front log to
hide the burner as seen in Figure 68.
Note: Do Not Block Burner Ports with
Embers
Removal
1. Remove embers from replace.
2. Lift the decorative log off of the front log and
remove it from the rebox.
3. Lift the front log off of the burner and remove it
from the rebox.
4. Lift the back log over the pilot and burner and
remove from rebox.
Figure 64: Log Set
Figure 65: Rear Log Installation
5055.633-B
Log Set Installation / Removal
Figure 66: Front Log Installation
Figure 67: Decorative Log Installation
Figure 68: Ember Placement
Figure 69: Complete Log Set
34
BRSL.BODYB
140515-44
BDFD.BODYB