Pacific energy BRISTOL Installation And Operating Instructions Manual page 30

INSTALLER
INFORMATION
5. Remove two screws which hold the back ledge (Fig.50) in place and remove.
6. Remove the approximately 25 screws hold the base plate (Fig. 51) to the frame of the rebox.
7. Gently remove the base plate (Fig. 52) and set aside to the right hand side of the rebox.
There is no need to disconnect any of the electrical or gas ttings.
Figure 52
5055.633-B
Figure 50 Figure 51
30
Figure 53
BRSL.BODYB
140515-44
BDFD.BODYB