Ifc Module; Operating Procedure - Pacific energy BRISTOL Installation And Operating Instructions Manual

OWNER'S
INFORMATION

IFC Module

The Pro ame2 Integrated Fireplace Control (IFC) module (Fig. 3) is a device that allows automatic ignition
and pilot ame supervision, and commands the functions of the hearth Heater. It's con gured to control the
ON/OFF main burner operation, giving the choice of both IPI (intermittent pilot ignition), and CPI (continuous
pilot ignition) modes. The Pro ame2 IFC module controls and connects directly to the pilot assembly and the
automatic valve using low electric power.
The IFC module can be powered by both an AC power supply, and battery pack for back up. The Pro ame2
offers the added ability to control the comfort fan speed from OFF through six (6) speeds, a remotely actuated
auxiliary outlet and a dimmable light outlet. The external batteries can provide DC power to the IFC allowing the
batteries to be used only when line power is interrupted or lost, and if the Heater does not use a combustion
fan

OPERATING PROCEDURE

Initializing the system for the rst time.
1.
Install 4 AA batteries into the battery bay (Fig. 4) located on the rear side behind the surround below the
rebox. Install the ON/OFF switch cover (Fig. 5) over top of the battery bay. Make sure that the selection
switch is on the "Remote" setting.
2.
Install 3 AAA batteries into the Pro ame2 Remote Transmitter (Fig. 1).
3.
Plug the power cord into the Brentwood/Broadway and open the gas supply line.
4.
Insert a straightened paper clip into the opening marked "PRG" of the ON/OFF battery bay cover
(Fig. 4 & 5) and press the program button once. The module will beep 3 times indicating that it is ready to
synchronize with a remote transmitter.
5.
On the remote transmitter, push the power on button once. The remote transmitter will beep 4 times to
indicate that the remote transmitter and the control module are now synchronized. The remote transmitter
is now ready to use.
3. IFC (integrated replace
control) module.
5055.633-B
Figure 4. On/Off switch. Position switch in the
middle to use the hand-held remote control
switch.
8
Figure 5. On/Off switch cover
BRSL.BODYB
140515-44
BDFD.BODYB