Log Set Installation/Removal - Pacific energy BROADWAY GBWY.BODYA Installation And Operating Instructions Manual

INSTALLER
Log Set Installation / Removal
INFORMATION
Installation
1. Position rear log against the back firebox as
seen in Figure 33.
2. Position front log just behind the front burner
tube as seen in Figure 34.
3. Position log 3 with the thin end of the log
resting on top of the right end of the front log
as seen in Figure 35.
4. Place ember chunks in front of the front log to
hide the burner as seen in Figure 36.
Note: Do Not Block Burner Ports with
Embers
Removal
1. Remove embers from fireplace.
2. Lift the decorative log off of the front log and
remove it from the firebox.
3. Lift the front log off of the burner and remove it
from the firebox.
4. Lift the back log over the pilot and burner and
remove from firebox.
Figure 34: Front Log Installation
Figure 36: Ember Placement
Figure 35: Decorative Log Installation
26
Log Set
Figure 33: Rear Log Installation
Figure 37: Complete Log Set