Adjustable Leveling Bolts; Door Installation/Removal; Installation; Removal - Pacific energy BROADWAY Installation And Operating Instructions Manual

Adjustable leveling bolts

Figure 34: Adjustment feet on the bottom rear of unit.
Figure 35: Releasing door screws.
NOTE:
In the event that the door glass breaks,
The complete door assembly must be replaced.
See "Replacement Parts" on page 37 for the
appropriate part number.
BDWY.BODYB
230216-44
BRNT.BODYB
Adjustable leveling bolts

Door Installation/Removal

23
This replace comes with two leveling bolts
used to adjust the angle of the front of the
replace relative to the wall in which it's
installed. The bolts are not pre-installed and
can be found in a separate plastic bag. Care
in measuring should be exercised if using
the bolts as the replace will be required
to be removed each time an adjustment is
performed.

Installation

1. Position the door so that the doors upper
bracket is positioned overtop of the lip on
top of the rebox.
2. Lower the bottom edge of the door and
secure it with 1/4" bolts to the relief arms
as shown in Figure 35.

Removal

1. Locate and remove the two 1/4" bolts
securing the bottom of door as seen in
Figure 35.
2. Tilt the bottom of the door away from the
appliance and lift the door off.
5055.66-B