Table of Contents
Advertisement
20
Step
Action
1
Connect the left support with the left rail, using three M5 nuts, three
lock washers, and three M5 x 10 screws. Leave them loose enough so
that you can adjust the length of the rail.
2
Align the holes in the front of the assembled rail with the front post
of the four-post rack, and secure it to the post with two location pins
and washers.
3
Attach the rear of the assembled rail to the rear post using two M5 x
10 screws, washers, and lock washers, then tighten the rail and
support.
4
Repeat Steps 1 through 3 for the right support rail.
5
Install the clip nuts for the disk shelf into the equipment rack posts.
Only one clip nut is required per side, located seven holes above the
top location pin of the mounting bracket.
6
Slide your R100 disk shelf onto the support rails and secure it to the
equipment rack. Before securing the disk shelf to the rack, be sure to
install the supplied spacers between the mounting flange of the disk
shelf and the mounting post of your rack, as shown in the following
illustration.
Installing an R100 disk shelf
Advertisement
Table of Contents
