NetApp NearStore R100 Hardware And Service Manual page 52

42
Step Action
2 A 100Base-TX/1000Base-T NIC
The following illustration shows a UTP cable with an RJ-45
connector connecting to a single-port 100Base-TX/1000Base-T NIC.
Note
The NIC is labeled 10/100/1000-TX; however, the chassis supports
only 100Base-TX/1000Base-T.
Push the cable with the RJ-45
connector into the RJ-45 port on
the NIC, until it clicks and locks
into place.
100Base-TX/1000Base-T card
Connecting an R100 chassis to an Ethernet network