Table of Contents
Advertisement
Chapter 7: Replacing Internal Chassis Components
Step
Action
3
Insert the DIMM straight into the slot. The DIMM fits tightly in the
slot, but should go in easily. If not, realign the DIMM with the slot
and try again.
Caution
Visually inspect the DIMM to verify that it is evenly aligned and
fully inserted into the slot; otherwise, the edge connector on the
DIMM does not make complete contact with the slot.
4
Push carefully, but firmly on the top edge of the DIMM until the
latches snap into place.
5
Go to
"Closing the PCB
carrier" on page 110.
97
Advertisement
Table of Contents
