Table of Contents
Advertisement
92
Step
Action
5
Lift the NVRAM III adapter out of the expansion slot and carefully
lay it over the side of the chassis.
This allows easy access for the removal of the NVRAM III battery.
Caution
If a dirty shutdown occurred, do not disconnect the NVRAM III
battery wire from the NVRAM III adapter. This disconnection causes
data loss.
6
Using a #0 or #1 Phillips screwdriver, loosen the two thumbscrews
securing the NVRAM III battery carrier to the chassis frame.
7
Lift the NVRAM III battery out of the PCB carrier and place the
battery and the still-connected NVRAM III adapter on the
nonconductive surface.
8
Remove all SDRAM DIMMs by following Steps 3 through 5 of the
procedure described in
Set the DIMMs aside for later use.
"Removing an SDRAM
DIMM" on page 95.
Replacing the motherboard
Advertisement
Table of Contents
