Setup Wizard Tabs - Xblue Networks X-50 Installation Manual

Programming Wizard
The Setup Wizard guides the administrator through the required setup parameters to make the X-50
operational. The Setup Wizard must be completed at least once, before gaining access to the "Advanced Setup"
programming area. If any of the parameters are unknown, just press "Next" and continue. All of these
parameters can be adjusted later using the "Advanced Setup" area.

Setup Wizard Tabs

•
WAN Settings
• LAN Settings
• Wireless Basic
• Internet Time
•
Numbering Plan
•
IP Trunks (if needed)
•
DID Trunks (Requires IP TRunk)
• Call Routing Table
Before beginning the installation process it is a good idea to gather as much networking
information as possible. This includes IP Addresses for the LAN, WAN, Default Gateway,
Subnet, etc. It is also a good idea to make a note of all MAC Addresses for all wireless
devices as well as system or voice network numbing plan, SIP trunk information and how
dialed numbers will be routed.
82
(See "WAN Port Settings" on page
(See "LAN Port Settings" on page
(See "Wireless Basics" on page
(See "Internet Time" on page
(See "Numbering Plan" on page
(See "SIP Trunks" on page
(See "SIP Trunks" on page 94.)
(See "Call Routing Table" on page
XBLUE Networks
83.)
87.)
89.)
90.)
91.)
94.)
97.)