Xblue Networks X-50 Installation Manual page 99

Calls can automatically be routed to a specific telephone (PSTN) or
Group of lines, a specific SIP IP Trunk or group of SIP IP Trunks or to
another X-50.
Using the routing table eliminates the need for users to remember, what
can be, complex dialing plans.
•
The "From" entry, works in conjunction with the "To" entry, and where the digit evaluation begins.
This entry can contain up to ten digits. When a dialed number falls within the "From" and the "To"
entries the call will be routed through the programmed destination.
The "To" entry must be a greater number than the "From" entry, or
the rule will be invalid.
•
The "To" entry, works in conjunction with the "From" entry, and where the digit evaluation ends. This
entry can contain up to ten digits. When a dialed number falls within the "From" and the "To" entries
the call will be routed through the programmed destination.
•
The "Min" entry, works in conjunction with the "Max" entry, and determines the minimum number of
digits required to be considered for evaluation.
• The "Max" entry, works in conjunction with the "Min" entry, and determines the maximum number of
digits that will be evaluated. Any digits that exceeds this number will not be evaluated.
•
The "del" (delete digits) column is the number of digits that will be deleted when the dialed digits
match the "From" and the "To" entry.
• The maximum number of digits that can be inserted, from the insert column is ten.
•
Calls can be routed to a specific telephone line, 1 through 6, a SIP IP Line, 1 through 8, between
other X-50 systems using the IGW group, or a group can be created using either telephone lines or
SIP IP Trunk Lines, or a combination of both.
XBLUE Networks
Programming Wizard
99