Quick Setup Guide; Installation; Getting Started; Wireless Key Telephone Handset - Xblue Networks PCS digital User Manual

Quick Setup Guide

This section is designed to get the wireless handset on line quickly and easily, using a
brief outline format.

Installation

The Wireless Key Telephone Handset is actually a full function key set without wires.
Therefore, each unit requires its own digital extension in the telephone system. The
digital extensions are plugged into the back of the base station, which is connected
wirelessly with up to two (2) handsets. Each telephone system can have a total of four
(4) wireless handsets (2 base units, each with 2 handsets).

Getting Started

The base unit, handset, charging base and electrical plug come as a kit. Before you
begin, make sure that all of these items are in good working order. Not shown here is the
wall mount plate that gets mounted under the base unit and the belt clip that attaches to
be back of the handset.

Wireless Key Telephone Handset

1) Unpack the wireless handset and charging base unit
a. The charging base requires electricity and it should be plugged into a 117
+ 10% AC outlet. When the handset is placed into the charging unit, the
red charging light will illuminate.
2) Open the back of the handset, found at the bottom, to install the supplied battery.
a. Unpack the battery
b. Plug the battery cable into the small white connector found at the bottom
of the handset; then clip the battery into place.
c. Replace the back cover
Wireless Key Telephone Handset
- 9 -