Xblue Networks X-50 Installation Manual page 147

Enable Wireless - At default the checkbox indicates that wireless is enabled - when enabled the wireless
•
name (SSID) will be broadcast and visible to anyone that is looking for wireless gateways.
Hide Access Point - It is possible to enable the wireless but not broadcast the name (SSID). Select the
•
Checkbox to enable "Hide Access Point", i.e. make it invisible or undetectable.
Clients Isolation - Prevents wireless clients from seeing one another even though they are on the same
•
network. Select the Checkbox to enable "clients isolation", thus isolating the clients from each other.
Disable WMM Advertise - Wi-Fi Multimedia is used as Quality of Service, controlling the throughput of
•
audio, vidio and voice applications. At default, this is disabled.
Enable Wireless Multicast Forwarding (WMF) - is a delivery protocol for information to a group of
•
destinations. Although most applications use unicast (broadcasting to a single location), WMF is typically
used in oneway streaming media. At default, this is disabled.
SSID - Service Set IDentifier is the name that identifies a particular wireless gateway or router. This name
•
is broadcast and easily found by another wireless devices. For security, it is a good idea to change the
default SSID name. It is a good idea to use a name that makes sense to the administrator, but not so
specific as to give away where the device is located.
Do's and Don't's when naming SSID
•
Do not use the company name, address, phone number
•
Do not use a personal name
•
Do not use a birth date or other personal information
•
Do not use an antagonistic name such as "BigDog" or "NetworkGenius"
•
Do not make the name tantalizing, such as "SEXY-BOX" or "SECRET"
•
Do select a name that contains both letters and numbers
•
Do select a name that is easy to recognize but not memorize
•
Do consider changing the SSID every few months
•
BSSID - Basic Service Set IDentifier is set to the Media Access Control (MAC) address of the X-50
•
gateway. This is a fixed parameter that cannot be modified.
Country - Select the country that the X-50 system will be installed. Based on the country select, the X-50
•
will automatically set the wireless channel.
Max Clients - Enter the maximum number (valid entries are 1 - 128) of client computers that will be
•
supported by the wireless access point.
Enable Wireless Guest Network - The Wireless Guess Network allows clients to join the wireless access
•
point ( X-50 VoIP Telephone System) without getting access to the network or other network clients. This
is similar to a "Hot Spot". Double Click on the Checkbox to enable the "Guest Network"
Guest SSID - At default the Guest SSID is set to "Guest" but should be changed as indicated in the SSID.
•
XBLUE Networks
Wireless Programming
147