Installing The X-50 Voip Telephone System; Before Programming The X-50 - Xblue Networks X-50 Installation Manual

Installation
X-50
Installing the
1. Remove all of the components from the box.
2. Wall Mount - locate the supplied wall template and secure it to the wall. Drill starter holes and place the
supplied anchors into the holes. Position the supplied screws into the anchors and secure them. It will be
necessary to back the screws out about 1/4 of an inch to securely hold the system on the wall.
3. Table or shelf Mount - There are two ways to mount the system on a table or shelf, vertical and horizontal,
neither has an advantage over the other.
Vertical Installation - the system comes with a special weighted base stand designed to secure the X-50
VoIP Telephone System in a vertical position.
Horizontal Installation - the system also comes equipped with "Rubber" feet at the bottom of the unit so
that it can be placed on a table or shelf with a low profile. The Antenna, for the Wireless LAN, will bend at 90
degrees so that it can be tilted upward.
The X-50 is designed to operate either vertically or horizontally.
Before Programming the
Because the X-50 is a complete Gateway and Router, including a DHCP server it is a good idea to do some basic
programming before connecting it to an existing network. Connect a PC to the X-50 LAN Port, using the supplied
Patch Cable and then power up the X-50 system. If the user's PC is set to DHCP, it will connect to the X-50 and
the two devices will become a network. The Gateway's default IP Address is 192.168.10.1.
80
VoIP Telephone System
X-50
XBLUE Networks