Xblue Networks X-50 Installation Manual page 155

Select "Wireless MAC Filtering", and then select "Add" to add a MAC address or "Remove" to remove servers
from the current list.
Enter the MAC Address for each client device and press save.
•
Locating a device's MAC Address:
Usually, the MAC Address can be found on a label, which is affixed to the
outside of the device, and labeled "MAC Address" However, some times it is
called something different such as physical, hardware or device address, but in
all cases the MAC Address is 6 Octets, which is 12 numbers or characters, and
should be written as xx:xx:xx:xx:xx:xx. In all cases, a label with the MAC
Address must be on the Printed Circuit Board of the device connecting to the
network.
A computer's MAC Address is easily found by going to the Command Prompt,
"Start --> Accessories --> Run" type CMD, and press enter.
Type [ipconfig /all] and press enter. The MAC Address will probably be written
as xx-xx-xx-xx-xx-xx.
XBLUE Networks
Wireless Programming
155